Wireless PTZ Transmitter Kit
These are great for professionals and DIYers looking to setup their PTZ camera wirelessly
where there is local power available. You connect the transmitter to your camera,
and the receiver connects to either a TV/Monitor or DVR. You can even connect a PTZ joystick
to the receiver to control the camera directly.
Cost effective and realiable wireless video and data transmitter and receiver kit for use with Pan Tilt Zoom cameras that are Pelco-D protocol compatible. This kit will work with any Pelco-D compatible PTZ camera, as well as any Turning Motor that works off of RS485. This wireless PTZ kit is designed for sending video, audio, and PTZ controls signals wirelessly all through one device. The data portion of the signal is a 2-way signa so you can send and receive PTZ signals from both transmitter and receiver.
These are capable of working up to 300 feet away but can be made to work over even longer distances with our panel antennas. We recommend the use of our 2.4GHz High Gain Panel Antenna to boost the signal. Keep in mind that wireless transmission is best with line of sight and you can always use a high gain antenna to boost your signal to run the signal farther.
These are great for professionals and DIYers looking to setup their PTZ camera wirelessly where there is local power available. You connect the transmitter to your camera, and the receiver connects to either a TV/Monitor or DVR. You can even connect a PTZ joystick to the receiver to control the camera directly.
Both the Transmitter and Receiver units are small (approx. 5 inches in width and length) and extremely light weight. The digital frequency hopping technology allows you to use multiple transmitters and receiver kits in one location. Since these units run on a digital wireless 2.4GHz signal they are great for use where there is WiFi or wireless internet signal without interference. Also great for use in open spaces or out in the country.
We recommend that you get an outdoor weather proof enclosure if you intend to leave these units outside.
GenralFrequency2400-2480 MHz, 25-CH Auto Hopping
(FCC & CE RTTE)RF TX Power100mW (Average)NoModulation16-QAM,QPSK,BPSKMin. RX SensitivityNo-80 dBMVideoVideo CompressionMPEG-4Max. Frame Rate vs. ResolutionNTSC: 30fps at 720 x 480 (D1)Bit RateUp to 6MbpsAudioSampling Rate48KHz, StereoS/N Ratio63dBDataRS4852-wire RS485 Half Duplex Baud Rate:
Fixed Formats: 1 Start bit, 1 Stop bit, 8 Data Bits,
No Parity 120ΩTermination Resistor
ON/OFF SettingLED IndicatorsRed LEDPower On and RF Link StatusGreen LEDRS-485 Data Link StatusMechanical & EnvironmentalPower Consumption230mA @ 12VDCOperation Temperature-10°C~50°CStorage Temperature-30°C~85°C